Setting Unit To Display Ppp While Pulse Welding (Dx And Lx Models Only) - Miller DYNASTY 200 DX Owner's Manual

6-5. Setting Unit To Display PPP While Pulse Welding (DX And LX Models Only)

1 Output Switch Pad
2 Pulser Switch Pad
3 Power Switch
To access the PPP while welding dis-
play, turn power switch on, and then
press the Output and Pulser switch
pads before the software version
OM-2240 Page 52
sel
1
And
clears the meters. Hold the switch pads
until [SEL] [−−−] or [SEL] [PPP] appears.
4 Encoder Control
5 PPP Meter Display
Turn Encoder to change between stan-
dard and (PPP) meter display.
When the (PPP) meter display feature is
active while pulse welding, the (PPP) will
5
PPP
− − −
2
V
Rear Panel
be displayed on the right meter display,
and the Meter Hold feature is disabled.
The (PPP) meter display feature will not
effect the normal amperage display or
Meter Hold capabilities when in a non-
pulse welding mode.
Press torch trigger or turn off power to
save setting and end this set-up.
4
3
Or