Miller DYNASTY 200 DX Owner's Manual page 57

B. Lock Out Levels (Continued)
Select Process
+/− 10 % Amperage Adjust Control
Turn Pulser Control On/Off
Remote Amperage Control
Level 4
Level 3
Pulser On/Off Control
A J
K
I
B
C L N
H
M
D G
F
E
Use Encoder Control To
Adjust Amperage +/− 10%
Of Preset Value.
Level 3
NOTE: Remote amperage control is
not available in level 3.
Includes all the functions of levels 1
and 2 plus the following:
+/− 10% adjustment of preset TIG
or Stick Weld Amps
Select desired process, TIG or
Stick, and use Encoder control to
adjust amperage +/− 10% of preset
amperage value, up to the limits of
the machine. If operator tries to go
beyond the +/− 10%, the amperage
(right) meter will display [L-3 ] as a re-
minder.
Pulser ON/Off Control
Gives operator the ability to turn on/
off the Pulser control.
When parameter change or selec-
tion is limited by lock level 3, [L-3] is
displayed as a reminder.
Level 4
Includes all the functions of levels 1,
2, and 3 plus the following:
Remote Amperage Control
Allows operator to use remote am-
perage control if desired. Remote
control operates from minimum to
maximum of preset amperage val-
ue. Connect remote control device
according to Section 4-7.
When parameter change or selec-
tion is limited by lock level 4, [L-4] is
displayed as a reminder.
OM-2240 Page 51