6-6. Stick Open-Circuit Voltage (OCV) Selection (All Models)
1
1
Process Switch Pad
2
Adjust Switch Pad
3
Amperage Switch Pad
4
Power Switch
To access the Stick OCV selection,
turn power switch on and then press
the Process, Adjust and Amperage
switch pads before the software ver-
sel
l
oc
And
sion clears the meters. Hold the switch
pads until [SEL] [L
] or [SEL] [
oc
noc
5
Encoder Control
6
Meter Display
Turn Encoder to change between low
OCV [SEL] [L
] and normal OCV [SEL]
oc
[
]. Active selection is displayed on
noc
the meters.
6
V
Or
Rear Panel
When Stick low OCV is selected, open-
) appears.
circuit voltage is between 9 and 14
volts. When Stick normal OCV is se-
lected, open-circuit voltage is approxi-
mately 80 volts.
Application: For most Stick applica-
tions use low open-circuit voltage. Use
normal open-circuit voltage for hard to
start Stick electrodes, or if required for
your particular application.
5
3
2
4
OM-2240 Page 53