Section 6 − Advanced Functions; Programmable Tig Start Parameters (Polarity, Amperage And Time) - Miller Maxstar 300 LX Owner's Manual

SECTION 6 − ADVANCED FUNCTIONS
6-1.

Programmable TIG Start Parameters (Polarity, Amperage And Time)

Accessing Programmable TIG Start Parameters (All Models)
A.
4
1
NOTE: The welding cycle can be execut-
ed while in the programmable start mode.
Before accessing programmable TIG
Start parameters, be sure that all proce-
dures and panel parameters are estab-
lished.
1 Process Switch Pad
2 Amperage Switch Pad
3 Power Switch
To access the programmable TIG Start
SEL
5
And
Parameters, turn power switch on, press
and hold the Process and Amperage
switch pads before the software version
clears the meters, and [SEL] appears. A
Main/Peak and % or S LED's will light.
4 Memory Switch Pad (If Equipped)
Press Memory switch pad to select de-
sired memory location (see Section
5-12).
Note: Each memory location has its own
set of start parameters.
Or
Or
V
Rear Panel
Press the Process switch pad to select
the desired process, TIG HF Impulse or
TIG Lift Arc (see Section 5-6). Both pro-
cesses use the same parameter values.
5 Output Switch Pad
Press Output switch pad to select de-
sired type of control (see Section 5-7).
Proceed to Section B, C and/or D.
To save changes and exit, turn power off.
2
Or
3
OM-2222 Page 35