Weld Output Terminals And Selecting Cable Sizes; Remote 14 Receptacle Information - Miller DYNASTY 200 DX Owner's Manual

4-6. Weld Output Terminals And Selecting Cable Sizes*

Y Turn off power before
connecting to weld out-
put terminals.
Y Do not use worn, dam-
aged, undersized, or
poorly spliced cables.
+ +
−
Output Receptacles
This chart is a general guideline and may not suit all applications. If cable overheats, use next size larger cable.
*
**Weld cable size (AWG) is based on either a 4 volts or less drop or a current density of at least 300 circular mils per ampere.
2
( ) = mm for metric use
***Select weld cable size for pulsing application at peak amperage value.

4-7. Remote 14 Receptacle Information

A J
K
I
B B
C L N
H
M
D G
F F
E E
*The remaining sockets are not used.
Note: If a remote hand control, like the RHC-14, is connected to the Remote 14 receptacle, some current value above min. must be set on the
remote control before the Panel or Remote contactor is turned on. Failure to do so, will cause current to be controlled by the panel control and
the remote hand control will not function.
OM-2240 Page 18
Weld Cable Size** and Total Cable (Copper) Length in Weld Circuit
100 ft (30 m) Or Less
10 − 60% 60 − 100%
Welding
Duty
Amperes***
Cycle
100 4 (20)
150 3 (30)
200 3 (30)
15 VOLTS DC 15 VOLTS DC
REMOTE REMOTE
OUTPUT
CONTROL CONTROL
AMPERAGE AMPERAGE
VOLTAGE
803 428-A
CHASSIS
Not Exceeding
150 ft 200 ft
(45 m) (60 m)
Duty
Cycle
4 (20) 4 (20) 3 (30)
3 (30) 2 (35) 1 (50)
2 (35) 1 (50) 1/0 (60)
Socket*
A Contactor control +15 volts dc.
OUTPUT
B Contact closure to A completes 15 volts dc
CONTACTOR
contactor control circuit and enables output.
C Output to remote control; +10 volts dc output to
remote control.
D Remote control circuit common.
E 0 to +10 volts dc input command signal from
remote control.
A/V F Current feedback; +1 volt dc per 100 amperes.
H Voltage feedback; +1 volt dc per 10 volts output.
G +15 volts dc GND
GND
K Chassis common.
250 ft 300 ft 350 ft
(70 m) (90 m) (105 m)
10 − 100% Duty Cycle
2 (35) 1 (50) 1/0 (60)
1/0 (60) 2/0 (70) 3/0 (95
2/0 (70) 3/0 (95) 4/0 (120) 4/0 (120)
Socket Information
400 ft
(120 m)
1/0 (60)
3/0 (95)
S-0007-E−