Miller DYNASTY 200 DX Owner's Manual page 42

Changing Programmable TIG Start Polarity (Dynasty Models Only)
B.
1 Amperage Switch Pad
2 Encoder Control
3 Amps Meter
Changing Programmable TIG Start Amperage (All Models)
C.
1 Amperage Switch Pad
2 Encoder Control
3 Amps Meter
OM-2240 Page 36
SEL E−
To adjust TIG Start Polarity proceed as
follows:
Press Amperage switch pad. Switch pad
LED turns on, and meter % LED turns on.
The current Start Polarity, (SEL] [E−] or [SEL]
SEL 20
To adjust TIG Start Amperage proceed
as follows:
Press Amperage switch pad. Switch pad
LED turns on, and meter A LED turns on.
The current Start Amperage is displayed
3
Or
1
[EP] is displayed on meters, and can be
adjusted (see Section 5-16) by turning
the Encoder control.
To change Start Amperage, proceed to
Section C.
3
Or Or
1
on the amps meter, and can be adjusted
(see Section 5-16) by turning the
Encoder control.
To change Start Time, proceed to Section
D.
2
Or
2