Section 6 − Advanced Functions; Programmable Tig Start Parameters (Polarity, Amperage And Time) - Miller Dynasty 300 SD Owner's Manual

SECTION 6 − ADVANCED FUNCTIONS
6-1.

Programmable TIG Start Parameters (Polarity, Amperage And Time)

Accessing Programmable TIG Start Parameters (All Models)
A.
4
5 1
NOTE: The welding cycle can be execut-
ed while in the programmable start mode.
Before accessing programmable TIG
Start parameters, be sure that all proce-
dures and panel parameters are estab-
lished.
1 Process Switch Pad
2 Amperage Switch Pad
3 Power Switch
To access the programmable TIG Start
Parameters, turn power switch on, press
and hold the Process and Amperage
SEL
6
And
switch pads before the software version
clears the meters, and [SEL] appears. A
Main/Peak and % or S LED's will light.
4 Memory Switch Pad (If Equipped)
Press Memory switch pad to select de-
sired memory location (see Section
5-15).
5 Polarity Switch Pad (If Equipped)
Press Polarity switch pad to select AC or
DC (see Section 5-6).
Or
Or
V
Rear Panel
Note: Each memory location and each
polarity (AC or DC) has its own set of start
parameters.
Press the Process switch pad to select
the desired process, TIG HF Impulse or
TIG Lift Arc (see Section 5-7). Both pro-
cesses use the same parameter values.
6 Output Switch Pad
Press Output switch pad to select de-
sired type of control (see Section 5-9).
Proceed to Section B, C and/or D.
To save changes and exit, turn power off.
2
Or
3
OM-358 Page 31