Operation Flow - Panasonic WJ-ND400K Setup Instructions

Operation flow

The operation flow of the recorder is as follows.
z
Rack mounting
x
Connections
c
Startup
v
Install the HDD units
Network settings
b
of the recorder
n
Network settings of a PC
Formatting of the
m
hard disk drives
Network settings
,
of the camera
.
Setup
⁄0
Start operation
Replacement of the
hard disk drives
Install the recorder in the rack. (Refer to the installation guide.)
Go to step 2 when not installing it in the rack.
Connect the recorder to each device. (Refer to the installation
guide.)
Turn on the power of the recorder. (Refer to the installation guide.)
When using extension units, turn the power of all the extension
units before turning on the power of the recorder.
Install hard disk drives in the recorder. (Refer to the installation
guide.)
When unformatted hard disk drives are installed, they will auto-
matically be formatted.
According to your needs, determine the operational mode.
Operate the buttons on the front panel of the recorder to configure
the network settings of the recorder. (Page 11)
Change the TCP/IP setting of the PC to conform to the settings of
the recorder. (Page 13)
Display the disk configuration menu and format the hard disk
drives. (Page 89)
Display the camera setup menu and configure the network set-
tings of the cameras. (Page 49)
Perform the required settings on the setup menu to start opera-
tion. (Page 8)
When necessary
It is possible to replace the hard disk drives without turning off the
power of the recorder. (Refer to the Installation guide.)
7