Disk - Panasonic WJ-ND400K Setup Instructions

Disk

Configure the settings to determine the action to be taken when the available capacity of the hard disk drives on
the recorder is running out.
1
Click the [Maintenance] button.
2
Click the [Disk] tab.
The "Disk" page will be displayed.
Setup items
Disk end mode
■ Normal recording area
The oldest data will be overwritten and saved as new
data when capacity of the normal recording area has
run out.
■ Event recording area
Determine the action to be taken when the capacity of
the event recording area runs out.
Continue (default): The oldest data will be overwritten
and saved as new data when capacity of the event
recording area has run out.
Stop: Recording will stop when the capacity has run
out.
■ Copy area
Determine the action to be taken when the capacity of
the copy area runs out.
Continue: The oldest data will be overwritten and
saved as new data when capacity of the copy area
has run out.
Stop (default): Copying will stop when the capacity has
run out.
3
Configure each setting item.
Refer to "Setup items" mentioned below.
4
Click the [Set] button.
HDD capacity warning
■ Normal recording area
Select a level of the remaining capacity to issue a warn-
ing when the remaining capacity of the normal record-
ing are reaches a specified level.
Off (default)/1% - 10%
■ Event recording area
Select a level of the remaining capacity to issue a warn-
ing when the remaining capacity of the event recording
are reaches a specified level.
Off (default)/1% - 10%
■ Copy area
Select a level of the remaining capacity to issue a warn-
ing when the remaining capacity of the copy are reach-
es a specified level.
Off/1% - 10% (default)
Hour meter warning
Select an operating time to issue a warning when the
operating time (hour meter) of the hard disk drive reach-
es a specified operating time.
10000h/20000h (default)/30000h
83