Model Memories - GRAUPNER MX-16S Programming Manual

Model memories

Calling up a model, erasing a model, copying model
The section on pages 18 and 19 explains the basic me-
thod of using the buttons, while the previous doub-
le page explains how to move to the Multi-function list
and reserve a new model memory. At this point we now
wish to start with the "normal" description of the indivi-
dual menu points in the sequence in which they occur
on the transmitter itself. For this reason we start with the
menu ...
Model memory
The transmitter can store up to 12 complete sets of mo-
del data, including the digital trim values set by the four
trim levers. The trims are automatically stored, which
means that the settings you have carefully established
through test-fl ying are not lost when you swap models. If
you have entered a model name in the »Base settings«
menu (pages 38 and 42), the name appears after the
model number.
Use the right-hand rocker button to select the »Model
memory« menu, and press ENTER or SELECT.
36 Program description – Model memories
model
Select model
If you now press the ENTER or SELECT button again,
you move to the »Call up model« sub-menu:
Use the right-hand rocker button to select from the list
the model you wish to use, and confi rm your selection
by pressing ENTER or SELECT. Pressing ESC takes
you back to the previous menu page without switching
models.
Notes:
• If the warning message "Throttle too high" appears
when you switch models, the throttle stick (C1) is set
towards full throttle and should be moved back to
idle.
• If the message "Set Fail-Safe" appears when you
switch models, you should check your Fail-Safe set-
tings. This only applies if the transmitter is set to
SPCM transmission mode.
• If the battery voltage is too low, it may not be possible
to switch model memories for safety reasons. In this
case the screen displays the following message:
Erasing a model
Hold the SELECT button pressed in, use the right-hand
rocker button to select the »clear model« sub-menu,
then press ENTER or SELECT.
Use the right-hand rocker button to select from the list
the model you wish to erase ...
... then press SELECT or ENTER. The program re-
sponds with the security query: "model ... to be erased?"
If you answer NO, the process is interrupted, and you
are returned to the previous screen page. If you answer
YES with the right-hand rocker button and confi rm your
choice with ENTER or SELECT, then the selected mo-
del memory is erased.
Caution:
The erasure process is irrevocable. All model memo-
ry data is reset to the factory default settings.