GRAUPNER MX-16S Programming Manual page 9

The sets contain:
mx-16s transmitter with Synthesizer transmitter modu-
le on the appropriate frequency band, integral 8NH-1700
mAh NiMH battery (type may differ), R16SCAN receiver
on the appropriate frequency, one C 577 servo, switch
harness.
Order No. 4701 35 MHz band (A- and B-band)
Order No. 4703 40/41 MHz band
Please refer to the table on page 113 for details of approved frequen-
cies in individual EU countries.
Specifi cation of R16SCAN receiver
Operating voltage 4,8 ... 6 V
Current drain approx. 24 mA
Spot frequencies, 35 MHz 61 ... 282 / 182 ... 191*
Spot frequ., 40 / 41 MHz 50 ... 92 / 400 ... 420**
Channel spacing 10 kHz
Sensitivity approx. 10 µV
Modulation PPM
Servo functions 8
Temperature range -15° ... +55° C
Aerial length approx. 1000 mm
Dimensions approx. 46 x 25 x 15 mm
Weight approx. 17 g
* Channels 60, 281 and 282 not approved for use in Germany
** 41 MHz approved for use in France only
Specifi cation of mx-16s transmitter
Transmission system
Synthesizer RF section
Channel spacing, Synthesizer
Maximum control functions
Control functions
Channel pulse width
Temperature range
Telescopic aerial
Operating voltage
Current drain approx.
Dimensions approx.
Weight approx.
SPCM und PPM (FM / FMsss)
35 MHz A-band and B-band
40/41 MHz band
Please refer to the table on page 13 for details of approved frequen-
cies in individual EU countries
10 kHz
SPCM = 8, PPM = 8
8 functions, 4 with trims
1,5 ms +/-0,5 ms
-15 ... +55°C
10-section, approx. 1150 mm long
9,6 ... 12 V
225 mA (approx. 65 mA excl. RF)
190 x 195 x 85 mm
870 g incl. transmitter battery
Accessories
Order No. Description
1121 Neckstrap, 20 mm wide
70 Neckstrap, 30 mm wide
3097 Wind-shield for hand-held transmitter
See page 111 for mx-16s Trainer leads
Replacement part
Order No. Description
3100.6 Telescopic aerial for mx-16s transmitter
Description of radio control system 9