GRAUPNER MX-16S Programming Manual page 59

Exponential function
If you wish to switch between two settings, select the
fi eld and assign a physical switch as described on
page 25. The assigned switch appears in the screen dis-
play together with a switch symbol which indicates the
direction of operation when you move the switch.
For example, the system enables you to fl y with a line-
ar curve characteristic in the one switch position, and to
pre-set a value other than 0% in the other switch posi-
tion.
To change the Expo value, fi rst select the right-hand
SEL fi eld, then use the right-hand rocker button in the
highlighted fi eld to set separate values for each of the
two switch positions:
Pressing CLEAR in the highlighted fi eld resets an alte-
red value to 0%.
Examples of different Expo values:
E x p o = + 1 0 0 % E x p o = + 5 0 %
0
1 2 5 1 2 5
1 0 0 1 0 0
% %
0 0 0
- 1 0 0 - 1 0 0
- 1 2 5 - 1 2 5
- 1 0 0 % 0 - 1 0 0 % 0 + 1 0 0 %
+ 1 0 0 %
S t i c k D e f l e c t i o n ® S t i c k D e f l e c t i o n ®
In these examples the Dual Rate value is 100% in each
case.
Combined Dual Rate and Expo
If you have entered values for Dual Rates and Expo, the
two functions are superimposed as follows:
E x p o = + 1 0 0 % , D / R = 1 2 5 %
1 2 5
1 0 0
%
0
- 1 0 0
- 1 2 5
- 1 0 0 % 0 + 1 0 0 %
S t i c k D e f l e c t i o n ®
e.g. "switch back":
and after moving switch "2" "front":
E x p o = - 1 0 0 %
1 2 5
1 0 0
%
Note:
0
In software terms it would be possible to assign one
of the two control switches G1 or G2 which are avai-
- 1 0 0
lable at the C1 stick, but since these are triggered at
- 1 2 5
- 1 0 0 % 0 + 1 0 0 %
+80% and -80% of the transmitter control travel, this
S t i c k D e f l e c t i o n ®
is not a very practical alternative.
E x p o = + 1 0 0 % , D / R = 5 0 % E x p o = - 1 0 0 % , D / R = 5 0 %
1 2 5 1 2 5
1 0 0 1 0 0
% %
0 0
- 1 0 0 - 1 0 0
- 1 2 5 - 1 2 5
- 1 0 0 % 0 + 1 0 0 % - 1 0 0 % 0
+ 1 0 0 %
S t i c k D e f l e c t i o n ® S t i c k D e f l e c t i o n ®
Dual Rate / Expo – Model helicopter 59