GRAUPNER MX-16S Programming Manual page 55

Table of Contents

Advertisement

Throttle limit in conjunction with the digital trim
When used with the throttle limit control, the C1 trim
places a marker at the set idle position of the motor; at
this point the motor can be stopped using the trim. If the
trim is in its end-range (see picture below), then a sing-
le click immediately takes you back to the marker, i.e. to
the pre-set idle position (see also page 26).
The cut-off trim only acts as idle trim on the throttle limit
in the bottom half of the travel of the throttle limit cont-
rol, i.e. the marker is only set and stored within this ran-
ge. For this reason the C1 trim display is also completely
suppressed as soon as the throttle limit control is moved
to the right of the centre position.
Marker line indicates last C1 trim position
(Idle setting)
Centre
Rotary throttle limit
control (CTRL 7)
Trim position at
which motor stops
Marker line displayed
only if rotary throttle
limit control is below
centre. The C1 trim bar
is suppressed above
"Centre"
Control settings – Model helicopter
55

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents