Virtual Odometer; Voice Functionality - Teltonika FM5300 User Manual

6.4 Virtual Odometer

Virtual odometer is used to calculate travelled distance in FM5300 as a separate I/O
element. When FM5300 detects movement, it starts counting distance using GPS signal: every
second it checks current location and calculates distance between current and previous point. It
keeps adding these intervals until it is time to make a record, then FM5300 records its location
and adds odometer value, which is equal to the sum of all distances, measured every second.
When record is made, odometer resets to zero and distance calculation starts all over again.
Virtual odometer as an I/O element can be also used with Trip feature, read chapter
7.3.1.3.3.

6.5 Voice Functionality

FM5300 has functionality to receive and make voice calls. To enable this functionality a
telephone handset with electret microphone and RJ-9 connector must be connected to "Audio"
port.
In "Global Parameters", "Call Settings" section (Figure 17) there are four parameters: "Call
number", "Call trigger", "Ringtone", and "Auto answer". To initiate a call an appropriate digital
input has to be selected as a "Call Trigger". To trigger the call selected input has to be connected
to the Ext. Battery (+). When DIN disconnected from Ext. Battery (+)the call is triggered, FM5300
dials the number which is defined in "Call Number" field. To initiate a call to FM5300 dial a
number of the SIM card that is inserted in FM5300. When FM5300 has an incoming call it can
play a selected tone from the "Ringtone" list. FM5300 will auto answer the call after number of
rings defined in "Auto answer" field.
"Voice Settings" (Figure 17) section includes settings for "Microphone level" to regulate
microphone sensitivity and "Speaker level" to define how loud will be the speaker.
For detailed "Voice Functionality" configuration parameters descriptions refer to chapter
6.5
Figure 16 Accelerometer settings
Figure 17 Voice and Call Settings
26