Table of Contents
Advertisement
3. After the radiator is thoroughly cleaned, clean out
debris that may have collected in the channel at the
radiator base.
4. Close the hood.
Brake Maintenance
Adjusting the Parking Brake
Interlock Switch
1. Stop the machine, move the deck lift switch fully into
the neutral-locked position, set the parking brake, and
remove the ignition key.
2. Remove the bolts securing the front panel and remove
the panel (Figure 75).
2
1
1. Bolts
2. Control panel
3. Loosen the 2 jam nuts securing the parking brake
interlock switch to the mounting bracket.
1. Brake-shaft sensor
2. Jam nuts
4. Move the switch up or down on the bracket until the
distance between the brake shaft sensor and the switch
plunger is 5/32 inch (3.9mm) (Figure 76).
54
G020875
Figure 75
Figure 76
3. Parking-brake-interlock
switch
4. 5/32 inch (3.9 mm)
Advertisement
Table of Contents
