Toro 30381 Operator's Manual page 21

Figure 17
1. Drive shaft
Note: If the rear of the cab is not high enough to clear
the control handles, evenly tighten the jacking bolts
on each side of the cab jack tube to raise the rear of
the cab (Figure 18).
Figure 18
1. Jacking bolts
2. Frame tube
5. Route the hoses as follows:
A. Route the tank hose under the lift cylinder and
between the cylinder-mounting brackets to the
valve (Figure 19).
B. Route the pressure hose along side the PTO shaft
to the valve (Figure 19).
Note: To emphasize the hose routing, the hoses
are shown without the hose covers installed.
1. Tank hose
6. Connect the drive shaft to the gear-box shaft in the
winter frame, and torque the bolts (5/16 inch) to 175
to 225 inch-lbs (20 to 25 N-m).
7. Install the roll pin (Figure 20).
21
Figure 19
2. Pressure hose