Table of Contents
Advertisement
Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
1
Adjusting the ROPS
No Parts Required
Procedure
1. Remove the hairpin cotter pins and remove the 2 pins
from the roll bar (Figure 4).
Description
No parts required
No parts required
No parts required
No parts required
Mower Deck or Polar Trac Kit (sold
separately)
Operator's Manual
Engine Operator's Manual
Parts Catalog
Operator Training Material
Pre-delivery Inspection Sheet
Engine warranty
CE certificate
Qty.
–
Adjust the ROPS.
–
Install weights.
Check the hydraulic fluid, engine oil,
–
and coolant levels.
–
Activate and charge the battery.
1
Install the mower deck/polar trac.
1
1
Read the manuals and view the
1
training materials before operating the
1
machine. Use the remaining parts for
1
the installation of attachments.
1
1
1
2
5
Right Side Shown
1. Roll bar
2. Pin
2. Raise the roll bar to the upright position and install the
2 pins and secure them with the hairpin cotter pins
(Figure 4).
Note: If you must lower the roll bar, push the bar
forward to relieve pressure on the pins, remove the
pins, lower the bar slowly, and secure it with the pins so
that it does not damage the hood.
15
Use
4
3
G004634
Figure 4
3. Hairpin cotter pin
Advertisement
Table of Contents
