Table of Contents
Advertisement
Figure 84
1. Right pump rod
2. Left pump rod
3. Ball joint
4. Bolt
7. Move the motion control lever forward and reverse,
then back to neutral. The wheel must stop turning or
slightly creep in reverse.
8. Move the throttle lever to the Fast position. Make sure
that the wheel remains stopped or slightly creeps in
reverse; adjust it if necessary.
9. Repeat steps 6 through 8 for the other side of the
machine.
10. Tighten the jam nuts at the ball joints (Figure 82).
11. Move the throttle lever to the Slow position and stop
the engine.
12. Remove the jumper wire from the wire harness
connector and plug the connector into the seat switch.
WARNING
Electrical system will not perform proper
safety shut off with jumper wire installed.
• Remove jumper wire from wire harness
connector and plug connector into seat
switch when adjustment is completed.
• Never operate this unit with jumper
installed and seat switch bypassed.
5. Jam Nut
6. Hex shaft
7. Ball joint
13. Lower the seat into position.
14. Remove the jack stands.
Adjusting the Maximum
Ground Speed
1. Disengage the PTO, move the motion control levers to
the neutral locked position, and set the parking brake.
2. Move the throttle lever to the Slow position, stop the
engine, remove the key, and wait for all moving parts to
stop before leaving the operating position.
3. Remove the bolts securing the front panel and remove
the panel (Figure 85).
2
1
1. Bolts
2. Control panel
4. Loosen the jam nut on the stop bolt for one of the
control levers (Figure 86).
1. Stop bolt
2. Control lever
59
G020875
Figure 85
Figure 86
3. Jam nut
4. 0.060 inch (1.5 mm)
Advertisement
Table of Contents
