Toro 30381 Operator's Manual page 23

Figure 24
1. Jacking bolts
12. At the rear-mounting points, secure the cab to the
machine with a bolt (1/2 x 3 inch), steel washer (1/2 x
2–1/2 inch), rubber washer (1/2 x 2–1/2 inches) and
nut (1/2 inch) as shown in Figure 25.
13. Tighten all four cab-mounting bolts until the rubber
mounts are compressed to a thickness of 7/8 inch.
Figure 25
1. Rubber mount
2. Cab-jack tube
2. Measurement area—22
mm (7/8 inch)
14. Tighten the bolts and nuts securing the rear-cab
mounts to the ROPS posts (Figure 26).
15. Adjust the floor jack if the bolts are binding and
difficult to remove.
1. Cab mount
2. Bolts and nuts
16. Loosen the jacking bolts and remove the cab-jack tube
from the cutouts in the cab floor (Figure 27).
23
Figure 26
3. ROPS post