Table of Contents
Advertisement
4. Roll the deck and frame into position and install the
5 bolts (3/4 inch), washers and nuts that connect the
deck frame to the rear frame.
5. Remove the mounting bracket and support tube to gain
access to the bolts on the right-hand side (Figure 9).
1. Mounting bracket
6. Torque the bolts to 265 ft-lbs (359 N-m).
7. Remove the clevis pins and the 8 mm (5/16
inch) self-tapping screw pin retainers securing the
vertical-tube support assemblies to the rear of the deck
frame.
8. Slide the drive shaft onto the gearbox shaft (Figure 10).
Figure 10
1. Drive shaft
2. Roll pin
9. Install the roll pin, and torque the bolts to 175 to 225
inch-lbs (20 to 25 N-m).
10. Install the floor plate using the 2 clevis pins (Figure 11).
Figure 9
2. Support tube
3. Bolt (5/16 inch)
4. Gear box
1. Clevis pins
11. Route and connect the hydraulic-pressure hose and
tank hose to the control valve (Figure 12).
12. Connect the electrical wires to the electrical connectors
(Figure 12).
1. Tank hose
2. Control valve
13. Install the rear of the deck-lift cylinder onto the pivot
pin and secure it with the retaining ring (Figure 13).
14. Secure the front of the lift cylinder to the mower frame
with the cylinder pin and screw (Figure 13).
19
Figure 11
2. Floor plate
Figure 12
3. Electrical connectors
4. Pressure hose
Advertisement
Table of Contents
