Brake Maintenance; Adjusting The Parking Brake - Toro Z Master Professional 6000 Series Operator's Manual

Figure 77
1. Hydraulic unit shrouds
6. Over each dipstick, remove the cover and the
bolt attached to the cover . Clean around each
dipstick and hydraulic unit
Figure 78
1. Cover
7. Position the seat.
g010169
g010207
(Figure 78).
g012434
2. Bolt

Brake Maintenance

Adjusting the Parking
Brake
Service Interval: After the first 100 hours
Every 500 hours thereafter
Check that the brake is adjusted properly before
adjusting.
1. Drive the machine onto a level surface.
2. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and engage the parking brake.
3. Shut off the engine, wait for all moving parts to
stop, and remove the key.
4. Raise the back of the machine and support the
machine with jack stands.
DANGER
Mechanical or hydraulic jacks may fail
to support machine and cause a serious
injury.
• Use a jack stand when supporting the
machine.
• Do not use hydraulic jacks.
5. Remove the rear tires from the machine.
6. Remove any debris from the brake area.
7. Rotate the drive-wheel release handle to
the released position. Refer to
Drive-Wheel Release Valves (page
8. Check if there is a visible gap between the
L-bracket and the linkage stop
55
-
EUTRAL LOCK
Using the
30).
(Figure 79).