Table of Contents
Advertisement
6. Check where the control lever is relative to notch in
console (Figure 83).
Note: It should be centered allowing lever to pivot
outward to the neutral lock position.
Figure 83
1. Neutral position
7. If adjustment is needed, loosen the nut and jam nut
against the yoke (Figure 82).
8. Applying slight rearward pressure on the motion
control lever, turn the head of the adjustment bolt
in the appropriate direction until the control lever is
centered in the neutral lock position (Figure 82).
Note: Keeping rearward pressure on the lever will
keep the pin at the end of the slot and allow the
adjustment bolt to move the lever to the appropriate
position.
9. Tighten the nut and jam nut (Figure 82).
10. Repeat steps 4 through 9 for the other control lever.
11. Install the front panel.
2. Neutral locked position
Adjusting the Traction Drive
for Neutral
This adjustment must be made with drive wheels turning.
DANGER
Mechanical or hydraulic jacks may fail to support
the machine and cause a serious injury.
• Use jack stands when supporting the machine.
• Do not use hydraulic jacks.
WARNING
The engine must be running to perform this
adjustment. Contact with moving parts or hot
surfaces may cause personal injury.
Keep hands, feet, face, clothing, and other body
parts away from rotating parts, muffler, and other
hot surfaces.
1. Raise the frame onto stable jack stands so that the drive
wheels can rotate freely.
2. Slide seat forward, unlatch it, and swing it up and
forward.
3. Disconnect the electrical connector from the seat
safety switch.
4. Temporarily install a jumper wire across terminals in
the wiring harness connector.
5. Start the engine, ensure that the throttle lever is midway
between the Fast and Slow positions, and release the
parking brake.
Note: The motion control levers must be in the
neutral locked position while making any adjustments.
6. Adjust the pump rod length on one side by rotating
the hex shaft, in the appropriate direction, until the
corresponding wheel is still or slightly creeping in
reverse (Figure 84).
58
Advertisement
Table of Contents
