Toro 30381 Operator's Manual page 22

Figure 20
1. Tank hose
2. Pressure hose
3. Cable tie
8. Adjust the floor jack to line up the 25 mm (1 inch)
holes in the frame, and install a coupler pin on each
side (Figure 21).
Figure 21
1. Coupler pin
4. Bolt (5/16 inch)
5. Roll pin
6. Hose cover
9. Adjust the floor jack to install the bolts (3/4 inch) on
each side (Figure 22). Torque the bolts to 265 ft-lb
(359 N-m).
1. Coupler pin
Note: The rear tires will need to be removed to torque
the rear bolts (3/4 inch). After torquing the frame
bolts, install the rear tires and torque the lug nuts to 65
to 85 ft-lbs (88 to 115 N-m).
10. Insert a rubber mount onto each cab mount at the
rear-mounting locations (Figure 23).
1. Cab mount
11. Lower the cab into position by slowly and evenly
loosening the jacking bolts on each end of the jacking
tube (Figure 24).
22
Figure 22
2. Bolt (3/4 inch)
Figure 23
2. Rubber mount