Toro 30381 Operator's Manual page 20

Figure 13
1. Retaining ring
2. Screw
15. Position the ROPS assembly onto the ROPS posts.
16. Install the bolt, nut, hair pin cotter and pin securing
each ROPS assembly to the ROPS posts (Figure 14).
Note: If installing an allied suppliers mower deck,
install ROPS Kit, part no. 117–9179.
1
2
5
Figure 14
1. ROPS
2. Pin
3. Cotter pin
17. Start the machine, raise and lower the deck, check for
leaks, and ensure that the hoses do not rub against the
frame.
3. Cylinder pin and screw
4. Deck-lift cylinder
4
3
G004634
4. Bolt and nut
5. ROPS post
Installing the Polar Trac Kit
1. Remove the traction unit from the shipping pallet.
2. Place a jack stand under each wheel motor and a floor
jack under the rear bumper (Figure 15) or suspend the
traction unit from an overhead hoist.
1. Rear bumper
3. Remove the 2 screws securing the winter frame
floor-plate cover to the floor, and remove the plate
(Figure 16).
1. Floor-plate cover
4. Carefully roll the winter-frame assembly into position
while routing the drive shaft through the frame tube
(Figure 17).
20
Figure 15
2. Floor jack
Figure 16
2. Mounting screws