Fuel System Maintenance; Servicing The Water Separator - Toro 30381 Operator's Manual

Traction unit
Hide thumbs Also See for 30381:
Table of Contents

Advertisement

Changing the Engine Oil And Filter
Service Interval: After the first 50 hours
Every 150 hours
Change the oil and filter initially after first 50 hours of
operation and then every 150 hours of operation thereafter. If
possible, run the engine just before changing the oil because
warm oil flows better and carries more contaminants than
cold oil.
1. Position the machine on a level surface.
2. Open the hood.
3. Set a drain pan under the oil pan and in line with the
drain plug (Figure 66).
Figure 66
1. Oil filter
4. Clean the area around the drain plug.
5. Remove the drain plug and allow the oil to flow into
drain pan.
6. Remove and replace the oil filter (Figure 66).
7. After the oil is drained, install the drain plug and wipe
up any oil that is spilled.
8. Fill the crankcase with oil; refer to Checking the Engine
Oil Level (page 30).
2. Drain plug
Fuel System
Maintenance
Note: Refer to Adding Fuel (page 29) for proper fuel
recommendations.
DANGER
Under certain conditions, diesel fuel and fuel
vapors are highly flammable and explosive. A fire
or explosion from fuel can burn you and others and
can cause property damage.
• Use a funnel and fill the fuel tank outdoors, in
an open area, when the engine is off and is cold.
Wipe up any fuel that spills.
• Do not fill the fuel tank completely full. Add fuel
to the fuel tank until the level is to the bottom
of the filler neck.
• Never smoke when handling fuel, and stay away
from an open flame or where fuel fumes may be
ignited by a spark.
• Store fuel in a clean, safety-approved container
and keep the cap in place.

Servicing the Water Separator

Service Interval: Every 400 hours
Every 400 hours
Drain water or other contaminants from water separator
(Figure 67) daily.
1. Place a clean container under the fuel filter.
2. Loosen the drain plug on the bottom of the filter
canister.
1. Water separator filter canister
3. Clean the area where the filter canister mounts.
4. Remove the filter canister and clean the mounting
surface.
5. Lubricate the gasket on the filter canister with clean oil.
48
Figure 67

Advertisement

Table of Contents
loading

This manual is also suitable for:

Groundsmaster 7210

Table of Contents