Toro 30381 Operator's Manual page 25

21. Raise the floor jack until the front tires are off of the
ground high enough to install the track beneath them,
and support the frame with jack stands.
22. Remove the front and center tires from the winter
assembly (Figure 30).
Figure 30
1. Front tire
23. Carefully lift the tracks over the rear wheel and front
hubs. The direction of the track rotation is printed
on the track. The 'V' design in the rubber track must
point forward.
CAUTION
The track guides have many pinch points.
Carefully grasp the rubber track on the outer
edges outboard of the steel guides when
moving the track.
24. Adjust the floor jack to a suitable height to install the
front tire. With another person, lift the front of the
track enough to carefully install the front tires (Figure
31).
Figure 31
25. Adjust the floor jack to a suitable height to install the
center tire. Lift the center of the track enough to install
the center tire (Figure 32). Torque the lug nuts to 65 to
85 ft-lbs (88 to 115 N-m).
26. Lower the floor jack until the front wheels support the
frame. Install the flat washers (1/2 inch) and locknuts
on the bogie-pivot stud (Figure 29) and torque to 75
ft-lbs (102 N-m).
Note: You may need to move the floor jack to the rear
bumper to raise the rear of the machine high enough to
install the flat washer and locknut.
27. Install the side access covers with the screws previously
removed (Figure 33).
1. Access covers
28. Install the winter frame floor-plate cover to the floor
with the screws previously removed (Figure 34).
25
Figure 32
Figure 33