GE MM300 Manual page 132
Motor management system/low voltage motor protection and control
Hide thumbs
Also See for MM300:
- Instruction manual (198 pages) ,
- Quick start manual (77 pages) ,
- Installation recommendations (21 pages)
Table of Contents
Advertisement
DEVICENET PROTOCOL
4–54
2.
Click Browse. The Device Selection dialog appears:
3.
Select the 1770-KFD driver. The devices on the network appear in the right panel of
the dialog:
4.
From the right panel,select the device you are commissioning and click OK. The Node
Commissioning dialog appears with the current settings for your 1747-SDN module.
The dialog should look similar to the one shown below:
MM300 MOTOR MANAGEMENT SYSTEM – COMMUNICATIONS GUIDE
CHAPTER 4: FIELDBUS INTERFACE
Hide quick links:
Advertisement
Table of Contents
