GE MM300 Manual page 122

DEVICENET PROTOCOL
4–44
Terminal Signal
3 Drain
4 CAN_H
5 V+
3. Connect the power adapter to the 1770 KFD module.
4. Connect the power out and power out common signals from the PLC power to the V-
and V+ terminals of the DeviceNet network. The terminal designations on the power
supply are shown below:
5. Locate the DeviceNet port connector on the front of the 1747 SDN DeviceNet scanner
module and insert the 10-pin linear plug into the connector. Connect the other end of
the DeviceNet cable into this connector.
6. Locate the DeviceNet connector on the MM300 (see top left-hand corner of the
diagram below) and connect it to the scanner using the DeviceNet Cable.
Function
Shield
Signal High
Power Supply
MM300 MOTOR MANAGEMENT SYSTEM – COMMUNICATIONS GUIDE
CHAPTER 4: FIELDBUS INTERFACE
Color
Non-insulated
White
Red