GE MM300 Manual page 129
Motor management system/low voltage motor protection and control
Hide thumbs
Also See for MM300:
- Instruction manual (198 pages) ,
- Quick start manual (77 pages) ,
- Installation recommendations (21 pages)
Table of Contents
Advertisement
CHAPTER 4: FIELDBUS INTERFACE
NOTE:
NOTE
MM300 MOTOR MANAGEMENT SYSTEM – COMMUNICATIONS GUIDE
7.
Browse and select the EDS file for MM300. Make sure that the Icon file is present in the
same folder as the EDS file.
8.
Save the DeviceNet file after registering the EDS file. Close the RSNetworx software
and reboot the PC.
You must reboot the PC to make sure that the EDS file is registered correctly.
9.
After rebooting the PC, restart the RSNetworx software and open the recently saved
DeviceNet file.
10. Click
Online on the toolbar. List of the available drivers in RSLinx software appears,
as shown below:
DEVICENET PROTOCOL
4–51
Hide quick links:
Advertisement
Table of Contents
