NEC Express5800/R320a-E4 User Manual page 69

*
In the table above, PCI module names correspond as follows:
PCI module (for CPU/IO module 0) - PCI module 10
PCI module (for CPU/IO module 1) - PCI module 11
IMPORTANT:
When the status of each disk becomes RESYNC, RECOVERY, CHECK or REPAIR, do not add
a disk, insert/remove HDD, power off or restart the system. Wait until the status turns to
DUPLEX. Check the status of RAID using the ftdiskadm command, which is described later in
this document. For more information, see the User's Guide (Setup).
Use only the hard disk drives specified by NEC. There is a risk of hard disk as well as the entire
device breakdown when you install a third-party hard disk drive.
Purchase two, paired hard disk drive of the same model to configure the hard drive redundancy.
For information on which HDD suits this device the best, ask your sales agent.
The operation such as mounting for a partition of an internal disk is done for the RAID device (md)
that is configured by Software -RAID but not for partition.
For the ftdiskadm command described later in this document, slot numbers of internal disks are
allocated as follows;
Disk slot number for H/W
PCI module 0 Slot 0
PCI module 0 Slot 1
PCI module 0 Slot 2
PCI module 0 Slot 3
PCI module 0 Slot 4
PCI module 0 Slot 5
PCI module 0 Slot 6
PCI module 0 Slot 7
PCI module 1 Slot 0
PCI module 1 Slot 1
PCI module 1 Slot 2
PCI module 1 Slot 3
PCI module 1 Slot 4
PCI module 1 Slot 5
PCI module 1 Slot 6
PCI module 1 Slot 7
Corresponding slot
PCI module 10 Slot 0
PCI module 10 Slot 1
PCI module 10 Slot 2
PCI module 10 Slot 3
PCI module 10 Slot 4
PCI module 10 Slot 5
PCI module 10 Slot 6
PCI module 10 Slot 7
Disk slot number for ftdiskadm
Linux Setup and Operation 3-3
PCI module 11 Slot 0
PCI module 11 Slot 1
PCI module 11 Slot 2
PCI module 11 Slot 3
PCI module 11 Slot 4
PCI module 11 Slot 5
PCI module 11 Slot 6
PCI module 11 Slot 7
Slot 1
Slot 2
Slot 3
Slot 4
Slot 5
Slot 6
Slot 7
Slot 8
Slot 9
Slot 10
Slot 11
Slot 12
Slot 13
Slot 14
Slot 15
Slot 16