Procedure in the ft server utility
Perform the procedure below before replacement of a component.
1.
Select the target component by using the ft server utility.
2.
Check the current state of the target component with the LEDs and event log.
3.
Click the [Show] button in [MTBF Information] of the target component.
4.
Click the [Clear] button in [MTBF Clear] of the target component.
You can verify the MTBF clearing result by confirming whether the reset is done when
the number of fault becomes 0 on the MTBF information of the target componet screen.
5.
5. Start the component.
Sample screen of ft server utility
Installing and Using Utilities 5-45
[PCI Module]