Confirm Start and Stop of CPU Modules
This section describes how to confirm the continuous system operation after stopping one of the
CPU modules.
Confirm that the CPU modules are duplicated.
1.
To check if the CPU modules are duplicated, see the status LEDs of the CPU modules.
2
[Indications of status LEDs when CPU modules are duplicated]
1
PRIMARY LED
2
DISK ACCESS LED
3
System FT LED
Use the ft server utility to stop the operation of a CPU module to remove.
2.
Move to the directory where the ft server utility of NEC ESMPRO Agent is installed.
# cd/opt/nec/esmpro_sa/bin/
Start the ft server utility.
# ./ESMftcutil
The screen of the ft server utility will appear.
Select [ftServer] - [CPU Module] - [CPU Module (to be removed)]. The screen of the CPU
Module(to be removed) will appear.
Select [CPU Module Start/Stop] - [Stop] to the stop of the CPU .Module.
* As for the CPU module to stop, select [CPU Module(ID:0)] to stop CPU module 0, select
[CPU Module(ID:1)] to stop CPU module 1.
1
LED
LED
Linux Setup and Operation 3-15
Secondary
(Operating)
(Operating)
Green
Green
System
Green
3
Primary
-
Green