FIGURE 1-15
10. Lift the LIB assembly part of the way out of the server chassis.
11. Disconnect the cable from the bezel assembly.
12. Remove the LIB from the server.
1.13.2
Installing a Lower Interface Board Assembly
1. Locate the new LIB assembly using the screw holes at each corner as guides.
The LIB printed circuit board (PCB) pushes onto (blind-mates) its connectors.
2. Screw the LIB into place.
3. Attach the bezel PCB, PSU, and system board cables.
4. Install the cover assembly.
1-24
Sun Fire V125 Server Service Manual • September 2006
Lower Interface Board Standoff and Screw Locations