Lower Interface Board Assembly; Removing A Lower Interface Board Assembly; Section 1.13, "Lower Interface Board Assembly - Oracle Sun Fire V125 Service Manual

3. Install the PCI slider assembly.
The arrow embossed on the slider should point to the rear of the server.
4. Install any PCI cards you removed.
5. Reconnect all system board cables and wiring harnesses.
6. Install the server's cover and tighten the screws.
1.13

Lower Interface Board Assembly

The interface board assemblies handle the connections between the system board
and the components in the front section of the server. The assemblies are positioned
in the front section of the server, behind the hard drives and system configuration
card reader assembly.
1.13.1

Removing a Lower Interface Board Assembly

1. Power off the server.
See Section 1.2, "Controlling Server Power" on page
2. Ensure that the server is properly grounded.
See Section 1.3, "Avoiding Electrostatic Discharge" on page
3. Remove all hard drives.
4. Remove DVD drive, if one is fitted in the system.
5. Remove the cover assembly.
See Section 1.4, "Opening the Server" on page
6. Disconnect the system board cable.
7. Disconnect the PSU cable.
8. Disconnect the system configuration card reader cable.
9. Unscrew the eight screws that secure the LIB to the server's chassis as shown in
the following figure.
1-2.
1-3.
1-5.
Chapter 1 Parts Removal and Installation 1-23