Removing The Bezel Assembly; Installing The Bezel Assembly; Hard Drives; Removing A Hard Drive - Oracle Sun Fire V125 Service Manual

1.6.1

Removing the Bezel Assembly

1. Power off the server.
See Section 1.2, "Controlling Server Power" on page
2. Ensure that the server is properly grounded.
See the instructions in
3. Hold the bezel firmly at both ends and rotate it down to its open position.
Grip the bezel at the points marked by the green triangles at each end to open it. Do
not attempt to open the bezel using a single gripping point or by holding the middle
of the bezel, as damage may occur.
4. Disconnect the cable connecting the bezel assembly to the server.
5. Unscrew the bezel hinges and remove them from the server.
1.6.2

Installing the Bezel Assembly

1. Locate the new bezel and hinges onto the server, and screw the bezel hinges to the
server.
2. Reconnect the bezel cable.
1.7

Hard Drives

For information on removing a hard drive while the operating server is running, see
the Sun Fire V125 Server Administration Guide.
1.7.1

Removing a Hard Drive

1. Ensure that you are properly grounded.
See Section 1.3, "Avoiding Electrostatic Discharge" on page
2. Open the front bezel.
3. Check that the blue indicator indicator is lit on the hard drive.
The blue indicator comes on when the hard drive is ready to remove.
Section 1.3, "Avoiding Electrostatic Discharge" on page
Chapter 1 Parts Removal and Installation
1-2.
1-3.
1-3.
1-11