Oracle Sun Fire V40z Manual

Replacing a Sun Fire V40z CPU Card
Replacing a CPU in a Sun Fire V40z Server
1. Turn off the system, including any attached peripherals.
Refer to the Sun Fire V20z and Sun Fire V40z Servers User Guide for full instructions
on powering off the server. It is not necessary to remove the system cover for this
procedure.
2. Remove the front bezel from the server by pressing in on the rubberized buttons
on each side of the bezel, then swinging the bezel top downward (see
FIGURE 1
3. Open the CPU card door, which is located under the hard drive bays, to access the
CPU card. Press in the two buttons on the door and swing it downward so that it
is open 180-degrees from the closed position (see
FIGURE 2
817-5339-10
Removing the Front Bezel
Opening the CPU Card Door
).
FIGURE 2
).
FIGURE 1
1