1.4.5
Removing the Whole Cover Assembly
1. Remove the front section of the cover assembly.
See
Section 1.4.1, "Removing the Front Section of the Cover Assembly" on page
2. Open the back section of the cover assembly.
See
Section 1.4.3, "Opening the Back Section of the Cover Assembly" on page
3. Remove the back section of the cover assembly.
4. Unclip the U-channel that runs across the server and remove it (
You must remove this bar to reach the cables that connect the front of the server to
the rear.
FIGURE 1-5
Removing the U-Channel
Chapter 1 Parts Removal and Installation
1-6.
1-7.
).
FIGURE 1-5
1-9