Load Filament - XYZ Printing da Vinci Jr. 1.0 User Manual

CHANGE SPOOL
First retrieve filament spool to install the filament
1
spool axle ring.
Install the sensor chip. Please pay special attention to
3
the position of the installation holes on the chip.
Place the assembled filament spool (with the spool axle
5
rings) on the filament holder on the left side of the printer.
7 Open the release arm and push the filament all the way
to the bottom so that the front end of the filament is
completely inserted into the feed module.

Load Filament

da Vinci
2 Take out and separate the filament spool
axle ring into its two components.
Insert the filament spool axle ring components
4
to either side of the filament spool, and use a
cruciform screwdriver to tighten and secure the
rings to the axle to complete the installation of
the filament spool axle rings.
Pull out a section of the filament and insert it into the
6
feed port.
Caution: Pay attention to the direction the
filament is being pulled out and ensure that the
filament spool axle is being rotated in the correct
manner.
April 2016
Ver.1
P 6