Load Filament - XYZ Printing da Vinci 1.1 Plus User Manual

Load Filament

1
Remove the filament
stopper and tape.
P 10
2
Install the new filament cartridge
into the empty slot.
4 Select "Filament" > "Cartridge " > "Load".
Insert filament into the guide hole until the printer starts to load
5
filament.
(When the loading begins, you will hear the sound of motor and
can see filament is pulled into the printer.)
Note : Before pushing the filament into the guide hole,
the filament while loading filament
at a 45° angle with a cutting pliers, filament loading will be easier.
7 If filament doesn't come out from the nozzle,please press
or
to finish.
3
Place and push to click the cartridge.
and cut the tip of the filament off
Wait for the printer to install
6
filament and heating extruder.
. When filament is dripping off the nozzle, tap
avoid bending
V1.2