XYZ Printing da Vinci Jr. 1.0 User Manual page 18

Install Scan Bed and Devices Calibration
When you find inaccurate scan results, please follow the steps for scanning devices calibration:
Push the print bed to proper position then install the Scan Bed.
Note: Please always press the button of Scan Bed before attach or remove it.
Wait until XYZscan shows the instructions of calibrating plate placement, place the plate at the
center of the turntable (with chessboard pattern facing the left and insert the tab at the bottom
of the calibrating plate into the hole at the center of the turntable), then the click "Calibrate now"
button.
Wait until XYZscan and the printer finish
calibration (for approx. 7 minutes)
Original model
SCANNING
Scanning result
before calibration
When XYZscan prompts of calibration completed,
remove the calibrating plate, and click "OK" to finish.
You may begin to scan.
da Vinci
April 2016
Ver.1
Scanning result
after calibration
In XYZscan,select
"Setting"> "Calibrate Now"
P 18