XYZ Printing da Vinci Jr. 1.0 User Manual page 21

Note:
The machine can be turned off only when the cooling fan of the print head stops running after the print is com-
pleted. Turning off the power directly may clog the print head.
This section describes how to clean the feed module. After heavy use of printer, if feeding of material becomes difficult or
impossible, please follow these steps.
Preparation of Tools
A. Cleaning brush that comes with the printer
A. Quick Cleaning
1 Use the "UNLOAD FILAMENT" function to loosen and
remove the filament.
B. Standard Cleaning
1 Use the screwdriver to remove the screw and open the
top cover.
3 Use the cleaning brush to scrub the gear; after removing residues of
filament on the gear, you can insert the guide tube and put the cover
back and then enjoy printing again.
Please peruse the product instruction manual before using this product.
B. Screwdriver (T10) for standard cleaning procedure
Important Notice
References:
Please refer to CLEAN NOZZLE
to remove the blocks out of the
print head.
2 Use the cleaning brush to scrub the feed gear back
and forth to remove the chips of filament out of the
gear. Replace the wire after the cleaning is completed.
2
Press the black rubber fixer on top of hole and pull
the guide tube out.
da Vinci
April 2016
Ver.1
P 21