XYZ Printing da Vinci Jr. 1.0 User Manual page 14

BUZZER
When the buzzer is turned on, the printer will output an audible signal when a button is pressed, print job is finished, or issue is
detected.
Buzzer is turned on by default. To switch off the buzzer:
buzzer on
off
on
Select "OFF" and press "OK" to change the setting.
LANGUAGE
You may switch the display language on the printer between English and Japanese.
The default lanague is English. To switch to Japanese:
language en
english
ニホンゴ
ニホンゴ
Select " "and press "OK" to change the setting.
ENERGY SAVE
LED luminaires are installed in the printing chamber. To save energy consumed, the lighting will go off after idling for 3 minutes (shown
as 03M on the display) by default.
To select a longer time interval:
energy save off
off
03m
06m
Select "06M" (for auto off after 6 minutes) or "OFF" (for never turn off the LED) and press "OK" to change the setting.
AUTO LEVEL
The printer will adjust the configuration based on the detecting result automatically while "AUTO LEVEL" is enabled. The printing
mode helps to improve printing quality with slower printing speed. You may switch off the function if necessary.
To change the setting of auto-level:
AUTO LEVEL [ON]
OFF
ON
Simply select "OFF" and press "OK" to change the setting.
RESTORE DEFAULT
All settings can be reset to factory default with a few clicks.
To reset all settings at once:
restore default
are you sure
no
yes
Simply select "YES" and press "OK" to reset.
SETTINGS
da Vinci
April 2016
Ver.1
P 14