Onkyo TX-NR905 Instruction Manual page 99

Advanced Setup—Continued
5
Use the Up and Down [
buttons to select "Unit," and then
use the Left and Right [
ENTER
buttons to select:
feet: Select if you want to enter
distances in feet. Can be set
from 0.5 to 30 feet in 0.5-foot
steps.
meters: Select if you want to enter
ENTER
distances in meters. Can be
set from 0.15 to 9 meters in
0.15-meter steps.
6
Use the Up and Down [
buttons to select a speaker, and
use the Left and Right [
ENTER buttons to specify the distance.
Specify the distance from the speaker
to your listening position.
Notes:
• You can specify different distances
for front Speakers A and front Speak-
ENTER
ers B, but not the other speakers (i.e.,
subwoofer, center, surround, and sur-
round back).
• The Center distance cannot be set if
the currently selected speakers
(Speakers A or Speakers B) is set to
BTL (page 51), or Center is set to
None (page 94) or Not Use
(page 97).
• The Surr Right and Surr Left dis-
tances cannot be set if the currently
selected speakers (Speakers A or
Speakers B) is set to BTL (page 51),
or Surround is set to None (page 94)
or Not Use (page 97).
• The Surr Back R and Surr Back L
distances cannot be set if Speaker
Type Front A or Front B is set to Bi-
Amp or BTL (page 51), Surr Back is
set to None (page 94) or Not Use
(page 97), or Powered Zone 2 is
being used (page 121).
• The Subwoofer distance cannot be
set if Subwoofer is set to No
(page 95).
7
Repeat step 6 for each speaker.
8
Press the [SETUP] button.
Setup closes.
Note:
]/[ ]
• This procedure can also be performed on the AV
receiver by using its [SETUP], [ENTER], and arrow
]/[ ]
buttons.
Speaker Level Calibration
These settings are set automatically by the Automatic
Speaker Setup function (see page 61).
With the Level Calibration settings, you can adjust the
level of each speaker while listening to the test tone so
that the volume of each speaker is the same at the listen-
ing position. You can adjust the levels of front Speakers
]/[ ]
A and front Speakers B independently. The other speak-
ers (i.e., subwoofer, center, surround, and surround back)
]/[ ]
use the same level settings for Speakers A and Speakers
B.
Note:
• The test tone is output at the standard level for THX,
which is 0 dB (absolute volume setting 82). If you nor-
mally listen at volume settings below this, be careful
because the test tone will be much louder.
1
RECEIVER
SP A
2
3
ENTER
ENTER
Press the [RECEIVER] REMOTE
MODE button, and then use the
remote controller's [SP A] or
[SP B] button to select Speakers
A or Speakers B, respectively.
Note:
• Speakers B cannot be selected if
Speaker Type Front B is set to Not
SP B
Use.
Press the [SETUP] button.
The main menu appears onscreen.
Use the Up and Down [
buttons to select "2. Speaker
Setup," and then press [ENTER].
The Speaker Setup menu appears.
2.Speaker Setup
1.Speaker Settings
2.Speaker Config
3.Speaker Distance
4.Level Calibration
5.Equalizer Settings
6.THX Audio Setup
]/[ ]
99