Connecting An Ri Dock; Connecting The Power Cords Of Other Components (North American And European Models Only) - Onkyo TX-NR905 Instruction Manual

Connecting Your Components—Continued

Connecting an RI Dock

■ If Your iPod Supports Video:
Connect your RI Dock's audio output jacks to the
AV receiver's GAME/TV IN L/R jacks, and connect
its video output jack to the AV receiver's GAME/TV
IN V jack.
(Onkyo DS-A2 hookup shown below.)
If you have an Onkyo DS-A1 RI Dock, connect its video
output jack to the AV receiver's GAME/TV IN S jack.
Notes:
• Enter the appropriate remote control code before using the AV receiver's remote controller for the first time (see
page 127).
• Connect the RI Dock to the AV receiver with an
• Set the RI Dock's RI MODE switch to HDD or HDD/DOCK.
• Set the AV receiver's Input Display to DOCK (see page 57).
• See the RI Dock's instruction manual for more information.
Connecting the Power Cords of Other Components (North American and
European models only)
The AV receiver has AC outlets on its rear panel that can be used to
connect the power cords of other components that you intend to use
with the AV receiver. These components can then be left turned on so
that they turn on and off as and when the AV receiver is set to On or
Standby.
Caution:
• Make sure that the total capacity of the components that you con-
nect to the AC OUTLETS does not exceed the stated capacity (e.g.,
TOTAL 120 W).
Notes:
• When the HDMI Control setting is set to Enable (page 109), the
AC outlets are on all the time regardless of whether the AV receiver
is set to On or Standby, or Ready mode in this case, so any compo-
nents connected to them cannot be turned on or off automatically.
• Onkyo components connected via
directly to a wall outlet, not an AC OUTLET on the AV receiver.
• The number of AC OUTLETS, socket type, and total capacity
depends on the country in which you purchased the AV receiver.
48
GAME/TV
V
RS232 IN 4
COMPONENT VIDEO ASSIGNABLE
MONITOR
IN 3 IN 2 IN 1(DVD)
OUT
Y
C /P
REMOTE B B
CONTROL
IN DIGITAL ASSIGNABLE
COAXIAL
IN 1
(DVD) C /P
R R
L
IN IN OUT
IN 2 (VCR/DVR)
L L
IN 3 (CBL/SAT)
R R
R
OPTICAL
PHONO
CD
IN 1
(GAME/TV)
ZONE2 R SURR BACK R
GND
ASSIGNABLE
GAME/TV
IN 2
(CD)
OUT
should be connected
■ If Your iPod Doesn't Support Video:
Connect your RI Dock's audio output jacks to the
AV receiver's GAME/TV IN L/R jacks.
(Onkyo DS-A2 hookup shown below.)
HDMI
ASSIGNABLE
IN 3 IN 2 IN
AUX 1 GAME/TV CBL/SA
V
S
IN IN IN IN
TAPE AUX 1 GAME/TV CBL/SA
FRONT R
Bi-AMP
FRONT R (BTL)
cable (see page 49).
European model
IN
L
RS232
COMPONENT VIDEO
R
IN 3
Y
GAME/TV
REMOTE C B /P B
CONTROL
DIGITAL ASSIGNABLE
COAXIAL
IN 1
(DVD)
C R /P R
IN
IN 2 (VCR/DVR)
L
IN 3
(CBL/SAT)
R
OPTICAL
PHONO
IN 1
(GAME/TV)
GND
IN 2
(CD)
OUT
AC INLET
AC OUTLET
AC 120V 60Hz
SWITCHED
120W 1A MAX.
AC OUTLET
AC 120V
AC 220-240V 50/60Hz
SWITCHED
100W 0.45-0.41A MAX.
American model
HDMI
ASSIGNABLE
IN 4 IN 3 IN 2 IN 1
ASSIGNABLE
MONITOR
IN 2 IN 1(DVD)
OUT
AUX 1 GAME/TV CBL/SAT
V
S
IN IN IN IN IN
OUT OU
L
R
CD TAPE AUX 1 GAME/TV CBL/SAT
ZONE2 R SURR BACK R
FRONT R
Bi-AMP
ASSIGNABLE
FRONT R
(BTL)
AC OUTLET
60Hz
SWITCHED
120W 1A MAX.