Name Edit; A/V Sync - Onkyo TX-NR905 Instruction Manual

Advanced Setup—Continued
5 Use the Up and Down [ ]/[ ]
buttons to select an option, and
use the Left and Right [
ENTER
buttons to change it.
The Source Setup menu items are
explained below.
ENTER
6 When you've finished, press the
[SETUP] button.
Setup closes.
IntelliVolume
With IntelliVolume, you can set the input level for each
input selector individually. This is useful if one of your
source components is louder or quieter than the others.
Use the Left and Right [
If a component is noticeably louder than the others, use
the Left [ ] button to reduce its input level. If it's
noticeably quieter, use the Right [
its input level. The input level can be adjusted from
–12 dB to +12 dB in 1 dB steps.
Note:
• IntelliVolume does not apply for Zone 2 or Zone 3.

A/V Sync

When using your DVD player's progressive scanning
function, you may find that the picture and sound are out
of sync. With the A/V Sync setting, you can correct this
by applying a delay to the audio signal. The delay can be
set from 0 to 250 milliseconds (msec) in 5 millisecond
steps.
Use the Up and Down [
input selector, and use the Left and Right [
tons to set the delay.
To view the TV picture while setting the delay, press
[ENTER].
4-2.A/V Sync
A/V Sync
(HDMI LipSync
Press Enter to see picture
104
]/[
]/[ ] buttons to set the level.
] button to increase
]/[ ] buttons to select an
]/[ ] but-
DVD
100msec
60msec)
If HDMI Lip Sync is enabled (see page 109), and your
TV or display supports HDMI Lip Sync, the displayed
delay time will be the A/V Sync delay time. The HDMI
]
Lip Sync delay time is displayed underneath in parenthe-
ses.
Note:
• A/V Sync cannot be set when the Pure Audio listening
mode is selected, or when the Direct listening mode is
used with an analog input source.

Name Edit

You can enter a custom name for each individual input
selector and radio preset for easy identification. When
selected, the custom name will appear on the display.
1
2
RECEIVER
3
ENTER
ENTER
Select the input selector to which
you want to give a custom name.
To name a radio preset, use the
[TUNER] button to select AM or FM,
and then select the preset.
Press the [RECEIVER] REMOTE
MODE button, followed by the
[SETUP] button.
Use the Up and Down [
buttons to select "4. Source
Setup," and then press [ENTER].
The Source Setup menu appears.
4.Source Setup
DVD
1.IntelliVolume
2.A/V Sync
3.Name Edit
4.Satellite Radio
5.SIRIUS Parental Lock
]/[ ]