Onkyo TX-NR905 Instruction Manual page 98

Advanced Setup—Continued
18 Press the [SETUP] button.
Setup closes.
Note:
• This procedure can also be performed on the AV
receiver by using its [SETUP], [ENTER], and arrow
buttons.
98
Speaker Distance
These settings are set automatically by the Automatic
Speaker Setup function (see page 61).
With the Speaker Distance settings, you can specify the
distance from each speaker to the listening position. You
can set the distances for front Speakers A and front
Speakers B independently. The other speakers (i.e., sub-
woofer, center, surround, and surround back) use the
same distance settings for Speakers A and Speakers B.
1
Press the [RECEIVER] REMOTE
MODE button, and then use the
RECEIVER
remote controller's [SP A] or
[SP B] button to select Speakers
A or Speakers B, respectively.
Note:
• Speakers B cannot be selected if
Speaker Type Front B is set to Not
SP A SP B
Use.
2
Press the [SETUP] button.
The main menu appears onscreen.
3
Use the Up and Down [
buttons to select "2. Speaker
Setup," and then press [ENTER].
ENTER
The Speaker Setup menu appears.
2.Speaker Setup
1.Speaker Settings
2.Speaker Config
3.Speaker Distance
4.Level Calibration
ENTER
5.Equalizer Settings
6.THX Audio Setup
4 Use the Up and Down [
buttons to select "3. Speaker Dis-
tance," and then press [ENTER].
ENTER
The Speaker Distance screen appears.
2-3.Speaker Distance
Unit
Left
Center
Right
ENTER
Surr Right
Surr Back R
Surr Back L
Surr Left
Subwoofer
Note:
• Speakers that you set to No or None
in the Speaker Configuration
(page 94) cannot be selected.
]/[ ]
]/[ ]
feet
12.0ft
12.0ft
12.0ft
12.0ft
12.0ft
12.0ft
12.0ft
12.0ft