Onkyo TX-NR905 Instruction Manual page 100

Advanced Setup—Continued
4 Use the Up and Down [
buttons to select "4. Level Cali-
bration," and then press
[ENTER].
ENTER
The Level Calibration screen appears
and the pink noise test tone is output by
the front left speaker.
2-4.Level Calibration
ENTER
Note:
• Levels cannot be adjusted for speak-
ers set to No or None in the Speaker
Configuration (page 94).
5
Use the Up and Down [
buttons to select a speaker, and
use the Left and Right [
ENTER
buttons to adjust the level.
Levels can be adjusted from –12 to
+12 dB in 0.5 dB steps (–15 to +12 dB
for the subwoofer).
Notes:
• You can set different levels for front
Speakers A and front Speakers B, but
not the other speakers (i.e., sub-
woofer, center, surround, and sur-
round back).
• The Center level cannot be set if the
currently selected speakers (Speak-
ers A or Speakers B) is set to BTL
(page 51), or Center is set to None
(page 94) or Not Use (page 97).
• The Surr Right and Surr Left levels
cannot be set if the currently selected
speakers (Speakers A or Speakers B)
is set to BTL (page 51), or Surround
is set to None (page 94) or Not Use
(page 97).
• The Surr Back R and Surr Back L
levels cannot be set if Speaker Type
Front A or Front B is set to Bi-Amp
or BTL (page 51), Surr Back is set to
None (page 94) or Not Use
(page 97), or Powered Zone 2 is
being used (page 121).
• The Subwoofer levels cannot be set if
Subwoofer is set to No (page 95).
100
Left -12.0dB
Center -12.0dB
Right -12.0dB
Surr Right -12.0dB
Surr Back R -12.0dB
Surr Back L -12.0dB
Surr Left -12.0dB
Subwoofer -15.0dB
]/[ ] 6
7
Note:
• Speaker levels can also be adjusted by using the dedi-
cated buttons on the remote controller. Press the
[TEST TONE] button to output the test tone. Use the
]/[ ]
[CH SEL] button to select each speaker, and use the
[LEVEL–] and [LEVEL+] buttons to adjust the level.
]/[ ]
Repeat step 5 for each speaker
so that the volume of the test
tone from each speaker is the
same.
If you're using a handheld sound level
meter, adjust the level of each speaker
so that it reads 75 dB SPL at the listen-
ing position, measured with C-weight-
ing and slow reading.
Press the [SETUP] button.
Setup closes.