Onkyo TX-NR905 Instruction Manual page 95

Advanced Setup—Continued
5 Use the Up and Down [
buttons to select "Subwoofer,"
and then use the Left and Right
ENTER [ ]/[ ] buttons to select:
Yes: Select if a subwoofer is con-
nected.
No: Select if no subwoofer is con-
nected.
Note:
ENTER
• The same setting is used for Speakers
A and Speakers B.
6 Use the Up and Down [
buttons to select "Front," and
then use the Left and Right
ENTER [ ]/[ ] buttons to select a
crossover frequency.
Notes:
• This setting can be set independently
for front Speakers A and front Speak-
ers B.
ENTER
• Fixed at Full Band if Subwoofer
(step 5) is set to No.
7
Use the Up and Down [
buttons to select "Center," and
then use the Left and Right
ENTER
[ ]/[ ] buttons to select a
crossover frequency.
If no center speaker is connected, select
None.
Notes:
• The same setting is used for Speakers
ENTER
A and Speakers B.
• Cannot be set if the currently
selected speakers (Speakers A or
Speakers B) is set to BTL (page 51).
• Cannot select Full Band if Front
(step 6) is set to anything other than
Full Band.
• For Speakers B, if any channel is set
to Full Band, Center is fixed at Full
Band.
]/[ ] 8
ENTER
ENTER
]/[ ]
9
ENTER
ENTER
]/[ ]
10
ENTER
ENTER
Use the Up and Down [
buttons to select "Surround," and
then use the Left and Right
[ ]/[ ] buttons to select a
crossover frequency.
If no surround left and right speakers
are connected, select None.
Notes:
• The same setting is used for Speakers
A and Speakers B.
• Cannot be set if the currently
selected speakers (Speakers A or
Speakers B) is set to BTL (page 51).
• Cannot select Full Band if Front
(step 6) is set to anything other than
Full Band.
Use the Up and Down [
buttons to select "Surr Back,"
and then use the Left and Right
[ ]/[ ] buttons to select a
crossover frequency.
If no surround back speakers are con-
nected, select None.
Notes:
• The same setting is used for Speakers
A and Speakers B.
• Cannot be set if Speaker Type Front
A or Front B is set to Bi-Amp or BTL
(page 51), Surround is set to None
(step 8), or Powered Zone 2 is being
used (page 121).
• Cannot select Full Band if Surround
(step 8) is set to anything other than
Full Band.
Use the Up and Down [
buttons to select "Surr Back Ch,"
and then use the Left and Right
[ ]/[ ] buttons to select:
1ch: Select if one surround back
speaker is connected.
2ch: Select if two (left and right)
surround back speakers are
connected.
Notes:
• The same setting is used for Speakers
A and Speakers B.
• Cannot be set if Speaker Type Front
A or Front B is set to Bi-Amp or BTL
(page 51), SurrBack is set to None
(step 9), or Powered Zone 2 is being
used (page 121).
Continue with step 11 on the next page.
]/[ ]
]/[ ]
]/[ ]
95