Onkyo TX-NR905 Instruction Manual page 65

First Time Setup—Continued
Reviewing the Results
Use the Up and Down [
buttons to select the settings that
you want to review, and then
ENTER
press [ENTER].
Auto Speaker Setup
Save
Review SP Config
Review SP Distance
Review SP Level
ENTER
Cancel
The options are:
Review SP Config
Review the speaker configuration
settings.
Subwoofer
Front
Center
Surround
Surr Back
Surr Back Ch
Review SP Distance
Review the speaker distance set-
tings.
Auto Speaker Setup
Review SP Distance
Left
Center
Right
Surr Right
Surr Back R
Surr Back L
Surr Left
Subwoofer
Review SP Level
Review the speaker level settings.
Auto Speaker Setup
Left
Center
Right
Surr Right
Surr Back R
Surr Back L
Surr Left
Subwoofer
Press [RETURN] to return to the pre-
vious screen.
]/[ ]
AUDYSSEY
AUDYSSEY
Auto Speaker Setup
Review SP Config
: Yes
: Full Band
: 80Hz
: 100Hz
: 150Hz
: 2ch
AUDYSSEY
: 15ft
: 15ft
: 15ft
: 7ft
: 7ft
: 7ft
: 7ft
: 15ft
AUDYSSEY
Review SP Level
: +12dB
: 0dB
: –12dB
: +3dB
: +4dB
: -6dB
: -3dB
: 0dB
Changing the Speaker Settings Manually
In some cases, the measurements taken by the automatic
speaker setup may not provide usable results. If running
the speaker setup a second time doesn't help, you'll have
to set the speaker settings manually (see pages 94–101).
Notes:
• For THX-certified speakers, the 80 Hz (THX) cross-
over frequency is recommended. If you use the auto-
matic speaker setup, you'll need to manually select
80 Hz (THX) for each THX-certified speaker (see
page 94).
• Because of the complexities of low-frequency sounds
and the way they interact with a room, THX recom-
mends setting the subwoofer level and distance manu-
ally.
Using a Powered Subwoofer
If you're using a powered subwoofer, as it outputs very
low-frequency sound and its position is usually low
down, it may not be detected by the automatic speaker
setup. In this case, increase the subwoofer's volume,
select its highest crossover frequency, and then try run-
ning the automatic speaker setup again. Note that if the
volume is set too high and the sound distorts, it may not
be detected, so use an appropriate volume level. If the
subwoofer has a low-pass filter switch, set it to Off or
Direct. Refer to your subwoofer's instruction manual for
details.
65