Onkyo TX-NR905 Instruction Manual page 62

First Time Setup—Continued
The onscreen menus shown in this manual may be
slightly different from what you see on your TV.
1
Turn on the AV receiver and the
connected TV.
On the TV, select the input to which the
AV receiver is connected.
2 Place the setup microphone at
the 1st measurement position,
SETUP MIC
and connect it to the SETUP MIC
jack.
Notes:
• Make sure the microphone is hori-
zontal.
• If there's an obstacle between the
microphone and any speaker, the
automatic setup will not work cor-
rectly. Set up the room as you would
when enjoying a DVD movie.
• Positioning the microphone close to
where your ears would normally be
will provide the best results. You can
set the height of the microphone by
using a tripod or level table.
3
Press [ENTER].
ENTER
A test tone is output by each speaker in
turn, as Audyssey MultEQ XT deter-
mines which speakers are connected.
This takes a few minutes.
Note:
• If any extraneous noise is picked up
by the microphone, the automatic
setup may not work correctly, so
keep quiet.
62
Auto Speaker Setup
Next
Please place microphone at center
of listening area at ear height.
Auto Speaker Setup
Do not unplug
microphone.
Please keep quiet.
Now Measuring...
4 The speaker detect results
appear.
Auto Speaker Setup
ENTER
Next
Retry
Cancel
:Yes
ENTER
"Yes" means that the speaker was
detected. "No" means that no speaker
was detected.
If you agree with the results, use
the Up and Down [
tons to select Next, and then
press [ENTER].
The options are:
Next: Proceed to the next step.
Retry: Return to step 2 and try again.
Cancel: Cancel the automatic speaker
setup.
5
The following screen appears.
Auto Speaker Setup
Next
Please place microphone at
2nd Position at ear height.
Place the setup microphone at
the next position (see page 61),
ENTER
and then press [ENTER].
Audyssey MultEQ XT performs more
measurements. This takes a few min-
utes.
Auto Speaker Setup
Do not unplug
microphone.
Please keep quiet.
Now Measuring...
6 When prompted, place the setup
microphone at the next position,
and repeat step 5.
:No
SP Detect Result
]/[ ] but-